USS4
UNIVERSAL SPEAKERS SIMULATOR
Some OEM sources/head-units have a test circuit that monitors the presence of a low-impedance load to enable audio outputs. When you connect this type of head-unit to the high-level inputs of an Audison bit processor, which has a high impedance load, audio outputs are silenced. By inserting the USS 4 between the source and the processor / amplifier, these problems are definitively solved. If there is a need to generate a remote signal to control the amplifier turn on/off, it is necessary to power* the USS4, providing the additional feature of the possibility to delay the signal from 1 to 8 seconds, so as to avoid annoying “bumps” upon ignition.
* In countries where the legislation on electromagnetic compatibility is not mandatory under ECE / UN Regulation no. 10/5
Related products
-
THG 6.5 II optional mesh grilles can be defined with only one word: unique. They are made with finest steel without any compromise, to overcome the absolute.
-
THG 3.0 II optional mesh grilles can be defined with only one word: unique. They are made with finest steel without any compromise, to overcome the absolute.
-
Brands, Morel, Tempo Ultra MKII, 2-Way Component Systems
6″ x 9″ 2-Way Component Speakers
Peak: 560 watts per pair / 280 watts each | RMS: 300 watts per pair / 150 watts each
Impedance: 4 Ohm | Frequency Response: 50Hz – 22,000Hz | Sensitivity: 92dB | Mounting Depth: 3.35″ (85mm)
High-Grade Ferrite Magnet | Copper Voice Coil Wire | Treated Paper Composite Cone
1.1″ Soft Dome Tweeter | MXR Direct Crossovers
-
6.5 Inch Midrange 2 OHM 4 Piece Bulk Pack No Retail Package
Leave a Reply